Short answer: fill the reservoir with white vinegar (or a vinegar-and-water mix), run it through the machine, then run fresh water through to rinse. But the amount of vinegar, whether to pause mid-cycle, and how many rinse cycles you need are different for every brand. Below are the exact procedures from five manufacturers (four owner’s manuals plus KitchenAid’s official cleaning guide), each linked to its source, so you can follow the one that matches your machine.
How this guide was made: every instruction below is taken from the official owner’s manual linked next to it. We have not tested these machines ourselves. If your model number is different, follow your own manual.
Vinegar ratios by brand (from the official manuals)
| Coffee maker (manual) | Vinegar amount | How the cycle runs | Rinse afterwards |
|---|---|---|---|
| Cuisinart PerfecTemp 14-Cup, DCC-3200C Series (booklet) | Fill the reservoir to capacity with 1/3 white vinegar and 2/3 water | Press and hold CLEAN until the CLEAN light flashes; the cycle ends with 5 beeps and the machine shuts off | One full reservoir of fresh, cold water |
| Mr. Coffee VB Series (user manual) | 4 cups (20 fl. oz.) undiluted white household vinegar, or Mr. Coffee Cleaner | Brew 3 cups, turn off and let stand 30 minutes, then brew the rest | Two full brew cycles of fresh water |
| Ninja DualBrew Pro CFP300 series (owner’s guide) | White vinegar up to the Travel Mug line (16 oz.), then water up to the Full line, or a descaling solution | Press CLEAN, then START BREW; the clean cycle takes about 75 minutes | One water-only cycle; run another if the taste remains |
| Bunn Speed Brew: GRX, BX, SBS, CSB1, CSB2, BTX, CSB3T (owner’s manual) | 1 quart (32 oz.) white vinegar | Pour in, leave the switch ON and let the vinegar sit at least 2 hours | Cycle fresh cold water 3 or more times, until you no longer smell vinegar |
| KitchenAid drip coffee makers (official cleaning guide, Oct 2025) | Reservoir filled to max with half white vinegar, half water (or a descaling agent / affresh tablets) | Run a brew or cleaning cycle; repeat if the cleaning indicator stays on | 2–3 brew cycles of fresh, cool water |

Notice how different these are: Mr. Coffee and Bunn use undiluted vinegar, KitchenAid uses half and half, Cuisinart dilutes it to one-third, and Ninja measures it to a line on the reservoir. That is why a single “universal” ratio is less reliable than your own manual.
Cuisinart DCC-3200C: step by step
From the Cuisinart DCC-3200C Series instruction booklet. Cuisinart recommends cleaning whenever the CLEAN light turns on.
- Remove the charcoal water filter from the water reservoir.
- Fill the reservoir to capacity with 1/3 white vinegar and 2/3 water.
- Press and hold the CLEAN button. When the CLEAN light flashes, the machine is in Clean mode. Release the button.
- When the cycle finishes, 5 beeps sound and the coffeemaker shuts off.
- If the CLEAN light comes on again, repeat with a fresh vinegar-and-water mix. Cuisinart notes that one cycle is usually enough.
- When the CLEAN light stays off, run one full reservoir of fresh, cold water to rinse.
- Put the charcoal water filter back in its holder.
Having other problems with this model? See our Cuisinart DCC-3200 troubleshooting guide.
Mr. Coffee VB Series: step by step
From the Mr. Coffee VB Series user manual. The manual recommends removing mineral deposits “regularly” with Mr. Coffee Cleaner or vinegar.
- If your model has a water filtration disk, remove it first.
- Pour 4 cups (20 fl. oz.) of undiluted white household vinegar into the reservoir (or one batch of Mr. Coffee Cleaner, mixed per the package).
- Put an empty paper filter or the permanent filter in the filter basket and close the lid.
- Center the empty decanter on the warming plate.
- Brew three cups of the solution.
- Turn the coffeemaker off and let it stand for 30 minutes.
- Brew the rest of the solution.
- Discard the solution, rinse the decanter, and throw away the paper filter (or rinse the permanent filter).
- Fill the reservoir with fresh water and run a full brew cycle.
- Repeat the fresh-water brew one more time.
Ninja DualBrew Pro (CFP300 series): step by step
From the Ninja DualBrew Pro owner’s guide. The orange Intelligent Clean Cycle indicator lights when a clean is recommended; if it is ignored, the brewer may stop and show “CLn”.
- Place the empty carafe under the brew basket.
- Fill the reservoir with white vinegar to the Travel Mug line (16 oz.), then add water up to (not past) the Full line. Ninja says to use only white vinegar. A coffeemaker descaling solution is the alternative.
- Press CLEAN, then START BREW. Do not remove the carafe; cancelling the cycle means the brewer will not be properly descaled.
- The cycle takes about 75 minutes. At the end the brewer beeps and shows “End”.
- Empty the carafe and wash the reservoir with warm, soapy water.
- Fill the reservoir with fresh water and run a water-only cycle (Grounds: Full Carafe Classic; Pods: 12 oz. Classic). Run another if the taste persists.
Each brew mode (Grounds, Pods, Hot Water) needs its own clean cycle; see our Ninja CFP300 guide and how to clean a Ninja coffee maker with vinegar.
Bunn Speed Brew: step by step
From the Bunn Speed Brew owner’s manual, which covers models GRX, BX, SBS, CSB1, CSB2, BTX and CSB3T. Bunn recommends this routine cleaning every 3 months, or more often with hard water.
- Slide the brew funnel into its rails and place the carafe under it.
- Pour 1 quart (32 oz.) of white vinegar into the top and close the lid. Empty the carafe when the liquid stops flowing.
- Leave the switch ON and let the vinegar sit in the machine for at least 2 hours.
- Switch the tank OFF, unplug the brewer and let it cool for at least 30 minutes.
- Remove the funnel, unscrew the sprayhead, clear its holes with a toothpick, wash it with dish soap and rinse it.
- Pour a carafe of fresh water in to flush the vinegar out. Repeat with fresh cold water 3 or more times, until you no longer smell vinegar.
- Reattach the sprayhead, plug in, switch the tank ON and wait about 15 minutes for it to reach brewing temperature.
What the manufacturers agree on
- Use white vinegar. None of these sources suggests other kinds.
- Remove the water filter first if your machine has one (Cuisinart, Mr. Coffee).
- Always finish with fresh-water rinse cycles before brewing coffee again.
- Never immerse the base of the coffeemaker in water (Cuisinart, Mr. Coffee).
- Hard water means more frequent cleaning (Cuisinart, Ninja, Bunn).
What about Keurig?
Keurig pod brewers have their own descaling procedure that uses Keurig’s descaling solution, so follow the guide for your model: how to descale a Keurig coffee maker and how to clean a Keurig coffee maker.
FAQ
How many times should I run water after cleaning with vinegar?
It depends on the brand: one full reservoir for the Cuisinart DCC-3200C, two full brew cycles for the Mr. Coffee VB Series, one water-only cycle (repeated if needed) for the Ninja CFP300, three or more for the Bunn Speed Brew, and 2–3 for KitchenAid drip coffee makers.
Can I use straight vinegar?
Some manuals say yes (Mr. Coffee VB, Bunn Speed Brew); others dilute it (KitchenAid: half and half; Cuisinart: 1/3 vinegar; Ninja: 16 oz. topped up with water). Follow the ratio in your own manual.
How often should I clean my coffee maker with vinegar?
Machines with a clean indicator tell you: Cuisinart says to clean whenever the CLEAN light comes on, and Ninja shows an orange clean indicator. Bunn recommends every 3 months, and KitchenAid about once a month if you brew daily. Does vinegar also deal with mold? See does vinegar kill mold in a coffee maker.
More fixes by brand and model: coffee maker troubleshooting index.